* When the computer is left on the power-saving screen for 1 hour, the display only shows the measurement unit. If MODE is pressed or a sensor signal is received while the powersaving screen is activated, the computer returns to the measurement screen. If the computer does not receive any signal for 10 minutes, the power-saving screen is activated and only the clock is displayed. Pressing MODE for 2 seconds when on the measurement screen resets all measurement data to 0 (excluding Odo). During measurement the measurement unit ( km/h or mph) flashes. Measurement starts automatically when the bicycle moves. Various settings can be changed on the menu screen. On the measurement screen, press MENU to go to the menu screen. E instead of the measurement value when Tm exceeds approximately 100 hours or Dst exceeds 9999.99 km. Pressing MODE switches the current function displayed at the bottom of the screen. When the computer is mounted on the bracket, pressing the dot section on the computer depresses the MODE button. * The tire size or ETRTO code is indicated on the side of the tire. Measure the actual tire circumference (L)Īfter ensuring that the tire pressure is appropriate, sit on your bike, roll it forward so that the tire makes one full revolution (use the valve or other marking as a reference), and measure the distance traveled on the road.Tire circumference can be determined by either of the following two methods: For instructions on how to start measurement, refer to "Starting measurement". Setup is completed and the computer switches to the measurement screen. * All data is deleted and the computer is reset to its factory default settings.Įnter the tire circumference of the front wheel in mm.Įach time MODE is pressed and held, settings switch from time display mode, to hours, to minutes. Press the AC button on the back of the computer. When using the computer for the first time, configure the initial settings. If the speed is not displayed, refer to the attachment conditions in steps 1, 2, and 4 again. Attach/detach computerĪfter attaching the computer, rotate the front wheel gently to check that current speed is displayed on the computer. * The magnet may be mounted at any position on spoke as long as attachment conditions are satisfied. The clearance between the speed sensor and the magnet is within 5 mm (3/16"). The magnet passes through the speed sensor zone. Mount the speed sensor in a position where the distance from the computer to the speed sensor is within the signal range. When mounting the bracket on a handlebar, adjust the angle of the bracket so that the back of the computer faces the speed sensor when the computer is attached.Ĭut the bracket band so that cut end will not cause injury. Cateye Padrone CC-PA100W - Cyclocomputer Manual
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |